Finding the fault

Fuel trims (STFT and LTFT): how to read them to find the fault

What short and long-term fuel trims are, which values are normal, and how to use them to tell a vacuum leak from a fuel pressure problem.

2 min read Updated November 14, 2026 Reviewed by Renzo Chacca

Guide contents

In short

  • Positive trims mean the computer is adding fuel (lean); negative trims mean it is removing fuel (rich).
  • Short plus long-term trim should stay within ±10% on a warm engine.
  • Compare idle, 2,500 rpm and light load: the pattern points to the cause.
  • High at idle and almost normal at 2,500 rpm usually means a vacuum leak.

Fuel trims are probably the most useful live data for diagnosing a gasoline engine. They tell you how much fuel the computer is adding or removing to keep the mixture correct. Once you learn to read them, you will solve most P0171, P0172, P0174 and P0175 codes without swapping parts at random.

What each trim measures

  • STFT (short-term fuel trim): the immediate correction the computer applies based on the front oxygen sensor reading. It changes several times per second.
  • LTFT (long-term fuel trim): the learned correction. When the short-term trim stays off for a while, the computer moves it into the long-term trim and stores it in memory.

Both are expressed as percentages. A positive value means the computer is adding fuel because it sees a lean mixture. A negative value means it is removing fuel because it sees a rich mixture.

Normal values

With a warm engine in closed loop, the sum of STFT and LTFT should be between −10% and +10%. Between 10% and 20% there is a deviation worth checking, and from about 25% most computers set a lean or rich code. On engines with two banks, compare bank 1 with bank 2: the difference between them is a very valuable clue.

The three-condition test

Write down the trims in three situations: at idle, at about 2,500 rpm with no load, and driving under light load. The pattern points to the likely cause:

PatternLikely cause
Very positive at idle and almost normal at 2,500 rpmVacuum leak: unmetered air matters a lot at idle and little when more air is flowing.
Positive in every condition and worse under loadFuel starvation: weak pump, clogged filter, regulator or dirty injectors.
Positive and proportional to airflowA dirty MAF sensor that under-reports airflow.
Positive on one bank onlyA vacuum or exhaust leak on that side, or that bank's injectors.
Negative in every conditionToo much fuel: high pressure, a leaking injector, a saturated canister or oil diluted with gasoline.

How to confirm a vacuum leak

With high trims at idle, briefly pinch the suspect hoses or use a smoke machine. If the short-term trim drops sharply when you block a leak, you have found it. You can also do the opposite: very carefully, and with no flames nearby, introduce a little propane or carburetor cleaner near the suspect area. If the short-term trim falls, the engine is drawing air there.

After the repair

The long-term trim takes a while to return to normal. You can reset the learned values with the scan tool, if the function is available, or let the computer relearn while driving. Check the three conditions again: if the sum stays within ±10%, the mixture is corrected.

If a trim never moves and the oxygen sensor does not switch, the engine may be in open loop because of another fault. Check the oxygen sensor and the coolant temperature first.

Keep reading

All diagnostic guides