P0895Generic code

P0895 Code: Shift Time Too Short

The P0895 code means a gear change finished too quickly, which causes harsh shifts, usually from high pressure or mismatched adaptations. A transmission relearn with a scan tool often solves it. Keep driving with caution until it is addressed.

Severity
Medium
Can I keep driving?
Yes, but with caution
Estimated cost
$0 to $800
Difficulty
Medium
System
Transmission
Applies to
All OBD2 vehicles

Updated Reviewed by Renzo Chacca

On this page

What the P0895 code means

The computer measures how long each shift takes. If it is too short, the clutch applies with a bang, which means harsh shifts and extra wear. It usually comes from excessive pressure or from adaptations that no longer match the condition of the transmission.

On any transmission code, the first check is the fluid. Check the level using the manufacturer procedure, which often means the engine running and the fluid at a specific temperature. The fluid should be red or pink and should not smell burnt. Low or degraded fluid causes slipping, harsh shifts and solenoid or ratio codes that disappear once it is corrected.

Read up on the P0700 code as well, since it explains how transmission codes are read and why you need a scan tool that can talk to the transmission module.

After a fluid change or a transmission repair, the old adaptations are no longer valid. The transmission applies the clutches with the pressure it learned for worn parts, and the shifts come out harsh. Resetting the adaptations and running a relearn usually fixes it, and that is the usual cure for the P0895 code.

P0895 code symptoms

  • Harsh shifts or jolts when changing gears.

Likely causes of the P0895 code

  1. Mismatched adaptations. They no longer fit the current condition of the transmission.
  2. High line pressure. It applies the clutches too suddenly.
  3. Pressure solenoid that does not regulate correctly.
  4. Wrong fluid. A different viscosity or friction characteristic.

How to diagnose the P0895 code step by step

  1. Clear the adaptations and run the relearn procedure.
  2. Measure the line pressure.

How to fix the P0895 code

  • Perform the relearn.
  • Replace the pressure solenoid if it is failing.
  • Change the fluid to the specified type.

Technical reference data

  • Typical shift duration: 0.3 to 0.8 seconds.
  • Approximate values only: check the manufacturer data for your vehicle.

Brand-specific notes

A relearn done with a scan tool fixes many cases of this code. Ask the shop whether they can run one before they quote you for parts.

Frequently asked questions about P0895

Can I drive with a P0895 code?
Yes, with caution. The harsh shifts are hard on the transmission over time, so do not put it off for long.
What usually fixes it?
A transmission relearn done with a scan tool. It resets the adaptations so the clutches apply with the right pressure again.
Is the P0895 code serious?
Not in the short term. Left alone, the harsh shifts add wear to the clutches.
How much does it cost to fix P0895?
Between $0 and $800. A relearn can cost little or nothing, while a pressure solenoid replacement costs more.
What does the P0895 code mean?
The P0895 code is a generic OBD2 code that means a gear change completed faster than the computer expects, which usually shows up as a harsh shift.
Will a P0895 code clear itself?
It might go away after several drive cycles if the adaptations settle, but if the pressure is too high it will come back.
What is the most common cause of P0895?
Adaptations that no longer match the transmission, often after a fluid change or a repair.

Related codes

Questions about the P0895 code

There are no questions about this code yet. Tell us about your case: vehicle, symptoms and what you have already checked.