P0617 Code: Starter Relay Circuit High

What the P0617 code means

On many vehicles the computer turns on the starter through a relay, after checking that the brake is pressed, the shifter is in P or N and the key is valid.

The computer watches the control circuit from its own driver transistor. The P0617 code means high voltage in the control circuit (an open circuit or a short to voltage). Before you replace the component, check the fuse, relay, connector and wiring, which are the most usual cause.

A relay that does not close leaves the vehicle unable to start. One that sticks keeps the starter turning after the engine starts, which can damage the pinion and the ring gear. Swapping the relay with an identical one from the fuse box is the quickest test.

To confirm it, measure the continuity of each wire between the component connector and the computer connector with the key off. It should be less than 1 ohm. An infinite reading means the wire is open. If the wiring is good, measure the component itself: infinite resistance confirms it is open inside.

P0617 code symptoms

• Check engine light or another warning light on.
• The engine does not start.
• The engine does not crank and you do not hear the starter.
• The starter keeps turning after the engine starts (stuck relay).

Likely causes of the P0617 code

1. Loose or broken connector. The most common cause, especially after another repair.
2. Open coil or motor with infinite resistance.
3. Cut control wire between the component and the computer.
4. Short to 12 V. The control wire touches another wire that carries voltage.

How to diagnose the P0617 code step by step

1. Activate the component with the scan tool and check whether it responds.
2. Check the fuse and relay. Measure voltage on both sides of the fuse and swap the relay with an identical one.
3. Measure the supply at the connector. You should see battery voltage with the key on or when you command it.
4. Measure the component resistance and compare it with the manual, and also check the insulation to ground.
5. Check the control wire for continuity to the computer and for the absence of shorts.

How to fix the P0617 code

• Repair the connector, the wiring or the power supply.
• Replace the starter relay if it does not respond with correct power and command.
• Clear the codes and verify.

Technical reference data

• 12 V relay, with a coil of 50 to 100 ohms.
• Reference values only: check the manufacturer data for your vehicle.

Brand-specific notes

This is very frequent on GM, Chrysler and Hyundai vehicles with computer-controlled starting.

P0617 on GM

Very frequent on GM vehicles with computer-controlled starting.

P0617 on Chrysler

Very frequent on Chrysler vehicles with computer-controlled starting.

P0617 on Hyundai

Very frequent on Hyundai vehicles with computer-controlled starting.

Frequently asked questions about P0617