P0480 Code: Cooling Fan 1 Control Circuit
The P0480 code indicates an electrical fault in the control circuit of the cooling fan. A fan that does not run can overheat the engine in slow traffic and leave the A/C blowing warm. Check the fuse, relay, connector and wiring before replacing the fan.
- Severity
- High
- Can I keep driving?
- Yes, but with caution
- Estimated cost
- $30 to $500
- Difficulty
- Medium
- System
- Emissions Control
- Applies to
- All OBD2 vehicles
On this page
What the P0480 code means
The electric fan pulls air through the radiator when the vehicle is moving slowly or stopped, and when the air conditioning is on. The computer turns it on with relays or with a speed control module.
The computer monitors the control circuit from its own driver transistor. The P0480 code indicates an electrical fault in the control circuit. Before replacing the component, check the fuse, relay, connector and wiring, since they are the most common cause.
If the fan does not run, the engine overheats in slow traffic and the A/C cools poorly. If it runs all the time, it drains the battery. Keep an eye on the temperature gauge until it is repaired.
Always start with the simplest things: fuse, relay and connector. Then check power, ground and signal with the part still connected (using back-probes), and finally the continuity of each wire to the computer. Only if all of that checks out should you replace the component.
P0480 code symptoms
- Check engine light on.
- Overheating in traffic or when stopped.
- A/C that cools poorly when stopped.
- Fan that never shuts off.
Likely causes of the P0480 code
- Damaged connector, whether loose, broken or corroded.
- Fuse or relay blown or with worn contacts.
- Cut or shorted wiring between the component and the computer.
- Failed component: a damaged coil, motor or internal electronics.
How to diagnose the P0480 code step by step
- Command the component with the scan tool and check whether it responds.
- Check the fuse and relay.
- Measure the supply at the connector: battery voltage with the key on or when it is commanded.
- Measure the component resistance and compare it with the manual. Also check the insulation to ground.
- Check the control wire for continuity and for shorts.
- Command the fan with the scan tool or by turning on the air conditioning.
- Measure the fan current. A worn motor draws too much.
- Check the high-current fuses.
How to fix the P0480 code
- Repair the connector, the wiring or the power supply.
- Replace the cooling fan if it does not respond with correct power and control.
- Clear the codes and verify that the monitor completes.
Technical reference data
- Typical draw: 10 to 30 A per fan.
- Approximate values only: check the manufacturer data for your engine.
Brand-specific notes
On many vehicles the two-speed fan uses resistors or a PWM module that burns out when the motor wears down.
Because a worn fan motor draws extra current, a current reading often catches a weak fan before it quits completely.
Questions about the P0480 code
There are no questions about this code yet. Tell us about your case: vehicle, symptoms and what you have already checked.